Support Forum

Well... it lives:
https://www.youtube.com/watch?v=GCVqBC3DK7Y

Hi, I am usng Elegoo Neptune printers so my advice may not apply to your machine, but check if you have a long 0,4mm needle in your printer kit. If filament blocks the nozzle you may be able to remove filament and pfte tube and put the needle thru the heated nozzle from above, In my case it saves a ...

Hello, Colleague from polish forum made a painting masks for me. Thanks to him I was able to paint quite nice markings: http://rctank.pl/forum/download/file.php?id=23081&mode=view/20240225_162152.jpg http://rctank.pl/forum/download/file.php?id=23082&mode=view/20240225_162203.jpg http://rctan...

After an incident with blown-up ESC capacitor (it was not correctly assembled) I managed to do first run of the model: https://www.youtube.com/watch?v=rzEg7KTTgmY Meanwhile I am working on the interior - battery, electronic box, loudspeakers. I also ordered a set of 2,5mm springs. I can make these m...

Hi, First layer of green paint done: http://rctank.pl/forum/download/file.php?id=22740&mode=view/20231212_212038.jpg http://rctank.pl/forum/download/file.php?id=22740&mode=view/20231212_212038.jpg http://rctank.pl/forum/download/file.php?id=22741&mode=view/20231212_212055.jpg http://rcta...

Thanks :) Swing arms do bend a bit, so I will probably print these parts once again, with ABS. The same for the springs - I just had 2mm wire "on stock". Now I have 2,5mm too, so I can make one more batch of springs and mabe mix them. I want to try putting harder springs as first and last ...

I am using PETG for all non-resin parts, I assume that if anything breaks - I'll fix it :) Model is assembled and primed. I guess tomorrow I will start painting it. Voila, two photos before priming: http://rctank.pl/forum/download/file.php?id=22689&mode=view/20231130_184410.jpg http://rctank.pl/...

No, I have attention span of a sparrow- I focused on Cromwell

BTW - you don't have the section for 1/6 Cromwell yet. I posted my thread directly in "Show off".

And here we go, ten days of printing, zero to ten different printers simultaneously :lol: I wouldn't have the patience to do it with one printer... http://rctank.pl/forum/download/file.php?id=22625&mode=view/1.jpg http://rctank.pl/forum/download/file.php?id=22625&mode=view/1.jpg http://rctan...

Hi,
I purchased your project a few days ago, printers are red-hot doing their job - soon I shall be able to show some progress

Meanwhile I have a request - could you add alternative parts 04-03A and 04-05A - add option to print a casted port frame separately on SLA?

Konrad / vanHasen